Commercial door hardware that works as a complete system
A commercial door can have a good lock and still perform badly because the closer, hinges, frame alignment or furniture is unsuitable. Abetta assesses the whole working door so the repair addresses the real fault rather than merely swapping the most obvious component.
Commercial hardware services
- Mortice locks and commercial cylindrical locks
- Lever furniture, pull handles and associated fixings
- Door closers and closer adjustments
- Exit and egress hardware
- Lock repair, replacement and rekeying
- Door alignment and hardware compatibility assessment
- Preparation for master key and restricted key systems
- Replacement of worn or unsuitable components
Door closers
A closer must shut the door reliably without slamming, stopping short or making access unnecessarily difficult. Incorrect adjustment can cause latch failure, damage hinges and frames, or create a door that users prop open. Closer selection and adjustment should consider door size, weight, wind exposure, traffic and the existing latch.
Exit and egress hardware
Exit doors need to allow appropriate egress while remaining secure from the outside. The correct solution depends on the building, door type and intended use. We inspect the existing arrangement and identify worn, damaged or incompatible hardware. Where specialist compliance advice is required, that should be confirmed with the relevant building or fire professional rather than guessed at the door.
Locks, furniture and cylinders
Commercial doors commonly use mortice locks, cylindrical locks, interchangeable cylinders and robust lever furniture. Hardware must suit the door preparation and usage. A heavily used entry may need a different solution from a low-traffic storeroom, even if both doors look similar.
Why doors stop latching properly
- The door or frame has shifted
- The closer no longer controls the door correctly
- Hinges or fixings are worn or loose
- The latch and strike are misaligned
- The lock body or cylinder is worn
- Weather, wind pressure or floor changes affect movement
Repeatedly forcing or slamming the door usually turns a small alignment issue into a larger repair.
Maintenance for high-traffic doors
Entries, common-area doors, amenities and fire-exit routes receive far more use than ordinary office doors. Regular inspection can identify loose furniture, slow latching, oil leakage from closers, worn cylinders and strike damage before the door becomes insecure or unusable.
Commercial door hardware FAQs
Can a door closer be adjusted instead of replaced?
Sometimes. If the closer is serviceable and suitable for the door, adjustment may restore operation. Leaking, damaged or undersized units may require replacement.
Why does the door latch only when pushed?
Common causes include alignment, closer adjustment, hinge wear or latch and strike problems. The complete door needs inspection.
Can existing locks be connected to a master key system?
Possibly. Compatibility depends on the cylinder format, keyway and condition. See our master key system service.
Do you supply commercial lock brands?
We work with established products we genuinely supply and service, including selected Lockwood, ASSA ABLOY, Carbine, Brava and compatible commercial hardware.
Send door details for an initial assessment
Provide the property suburb, door type, problem description and clear photographs of both sides of the door, the edge, frame and existing hardware. This helps narrow the likely scope before attendance.
Send Door Details